Atag VA4511AT User Manual download pdf (Page 73)

2. Adjust the water hardness setting to the

highest setting and perform 1 normal

washing programme without loading any

dishes.

3. Adjust the water hardness setting ac-

cording to the hardness of the water in

your area.

4. Adjust the rinse aid dosage.

Select and start a washing programme

Select the washing programme and

delay start with the door slightly

opened. The start of the programme

or the countdown of the delay start

will occur only after the closure of

the door. Until then it is possible to

modify the settings

1. Check that the baskets have been loaded

correctly and that the spray arms are free

to rotate.

2. Check that the water tap is opened.

3. Press the on/off button. The dishwasher

must be in setting mode.

4. Press the button corresponding to the re-

quired programme (refer to 'Washing

programmes' chart).

Close the appliance door, the pro-

gramme starts automatically.

Setting and starting the programme with

delay start

1. After having selected the washing pro-

gramme, press the delay start button until

the flashing number of hours for the delay

start shows in the digital display.

The start of the selected washing pro-

gramme can be delayed for between 1

and 19 hours.

2. Close the dishwasher door, the count-

down starts automatically.

3. The countdown will decrease with steps

of 1 hour.

4. The opening of the door will interrupt the

countdown. Close the door; the count-

down will continue from the point at

which it was interrupted.

5. Once the delay start has elapsed the pro-

gramme will start automatically.

Warning! Interrupt or cancel a

washing programme in progress

ONLY if it's absolutely necessary.

Attention! Hot steam may escape

when the door is opened. Open the

door carefully.

Interrupt a washing programme in

progress

• Open the dishwasher door; the pro-

gramme will stop. Close the door; the pro-

gramme will start from the point at which

it was interrupted.

Cancel a delay start or a washing

programme in progress

• Simultaneously press and hold the two

function buttons B and C until all the pro-

gramme lights come on.

• Cancelling a delay start will also cancel the

washing programme. You have to select

the washing programme again.

• If a new washing programme is to be se-

lected, check that there is detergent in the

detergent dispenser.

End of the washing programme

• The appliance will automatically stop and

an audible signal informs you of the end of

the washing programme.

1. Open the appliance door. The digital dis-

play shows zero.

2. Switch of the appliance.

3. Leave the appliance door ajar for a few

minutes before removing the dishes. This

way they will be cooler and the drying will

be improved.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The

dishes should therefore be allowed to cool

down before removing from the appliance.

•Empty the lower basket first and then the

upper one; this will avoid water dripping

from the upper basket onto the dishes in

the lower one.

73

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 83 84

Comments to this Manuals

No comments