Atag VA4511AT User Manual download pdf (Page 76)

1. Unplug the appliance and then turn off

the water.

2. Leave the door ajar to prevent the forma-

tion of any unpleasant smells.

3. Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location

where the temperature is below 0°C. If this is

unavoidable, empty the machine, close the

appliance door, disconnect the water inlet

pipe and empty it.

Moving the machine

If you have to move the machine (moving

house etc...):

1. Unplug it.

2. Turn the water tap off.

3. Remove the water inlet and discharge

hoses.

4. Pull the machine out together with the

hoses.

Avoid over tilting the machine during trans-

portation.

What to do if…

The dishwasher will not start or stops during

operation.

Certain problems can be due to the lack of

simple maintenance or oversights, which can

be solved with the help of the hints described

in the chart, without calling out an engineer.

Open the door and switch off the appliance.

Carry out the following suggested corrective

actions.

Fault codes and malfunction Possible cause and solution

• continuous flashing of the running programme

light

• intermittent audible signal

•

appears in the digital display

The dishwasher does not fill with water

• The water tap is blocked or furred with lime-

scale.

Clean the water tap.

• The water tap is turned off.

Turn the water tap on.

• The filter (where present) in the inlet hose fitting

at the water inlet valve is blocked.

Clean the filter.

• The water inlet hose has not been correctly laid

or it is kinked or squashed.

Check the water inlet hose connection.

• continuous flashing of the running programme

light

• intermittent audible signal

•

appears in the digital display

The dishwasher will not drain

• The sink spigot is blocked.

Clean out the sink spigot.

• The water drain hose has not been correctly laid

or it is kinked or squashed.

Check the water drain hose connection.

• continuous flashing of the running programme

light

• intermittent audible signal

•

appears in the digital display

Anti-flood device is activated

• Close the water tap and contact your local

Service Force Centre.

Malfunction Possible cause and solution

The programme does not start

• The dishwasher door has not been properly

closed.

Close the door.

• The main plug is not plugged in.

Insert the main plug

• The fuse has blown out in the household fuse

box.

Replace the fuse.

• Delay start has been set.

If dishes are to be washed immediately, cancel

the delay start.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Comments to this Manuals

No comments

Atag VA4511AT User Manual Page 76

Comments to this Manuals

Related products and manuals for Dishwashers Atag VA4511AT