Atag VA5511BT User Manual download pdf (Page 27)

Problem Possible solution

Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not clogged.

Make sure that the inlet hose has no kinks or bends.

The appliance does not drain the water. Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or bends.

The anti-flood device is on. Close the water tap and contact the Service.

After the checks are completed, activate

the appliance. The programme continues

from the point of interruption.

If the problem occurs again, contact the

Service.

If the display shows other alarm codes,

contact the Service.

If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a

lower position.

• The quantity of detergent is too much.

Stains and dry water drops on glasses

and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector to

a higher position.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying phase

or with a low temperature drying phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

• The quality of the combi detergent tablets

can be the cause. Try a different brand or

activate the rinse aid dispenser and use

rinse aid together with the combi deter-

gent tablets.

Refer to ‘HINTS AND TIPS’ for other

possible causes.

Activating the rinse aid dispenser

with the multitab function activated

1. Press the on/off button to activate the

appliance. Make sure that the appliance

is in setting mode, refer to ‘SETTING

AND STARTING A PROGRAMME’.

2. Press and hold buttons (4) and (5) at the

same time until the indicators of buttons

(3), (4) and (5) flash.

3. Press button (4).

• The indicators of buttons (3) and (5)

go off.

• The indicator of button (4) continues

to flash.

• The display shows the setting of the

rinse aid dispenser.

Off

4. Press button (4) to change the setting.

5. Deactivate the appliance to confirm the

setting.

6. Adjust the released quantity of rinse aid.

7. Fill the rinse aid dispenser.

TECHNICAL INFORMATION

Dimensions Width / Height / Depth (mm) 546 / 759 / 550

Electrical connection Refer to the rating plate.

Voltage 220-240 V

Frequency 50 Hz

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Comments to this Manuals

No comments

Atag VA5511BT User Manual Page 27

Comments to this Manuals

Related products and manuals for Dishwashers Atag VA5511BT