Atag VA61313KT User Manual Page 1

VA61313KTUser ManualDishwasher

2. Put 1 litre of water in the salt container(only for the first time).3. Fill the salt container with 1 kg of salt(until it is full).4. Carefully sha

Using the detergent2030BA DC1. Press the release button (B) to openthe lid (C).2. Put the detergent, in powder or tablets,in the compartment (A).3. If

Cancelling the delay startPress and hold the programme buttonuntil the appliance is in programmeselection mode.When you cancel the delay start, you ha

1. Set the highest level of the watersoftener.2. Make sure that the salt and rinse aidcontainers are full.3. Start the shortest programme with arinsin

CBA1. Turn the filter (B) counterclockwiseand remove it.2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.

CAUTION! An incorrectposition of the filters can causebad washing results anddamage to the appliance.Cleaning the spray armsDo not remove the spray ar

Problem and alarm code Possible cause and solutionThe appliance does not fill with water.• The end indicator flashes 1 time in‐termittently.• Acoustic

Refer to "Before first use", "Daily use", or "Hints andtips" for other possible causes.Once you have checked the applian

Problem Possible cause and solutionTraces of rust on cutlery. • There is too much salt in the water used for washing.Refer to "The water softener

Capacity Place settings 13Power consumption Left-on mode (W) 5.0Power consumption Off-mode (W) 0.501) Refer to the rating plate for other values.2) If

CONTENTSSafety information 2Safety instructions 3Product description 5Control panel 5Programmes 6Settings 7Before first use 9Daily use 10Hints and tip

156919310-A-312017When contacting the service department, have the complete type number to hand.You will find the addresses and phone numbers of the s

• Do not change the specification of this appliance.• The operating water pressure (minimum and maximum)must be between 0.5 (0.05) / 8 (0.8) bar (MPa)

• Connect the mains plug to the mainssocket only at the end of theinstallation. Make sure that there isaccess to the mains plug after theinstallation.

PRODUCT DESCRIPTION437 9 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Deterg

5Delay buttonIndicatorsIndicator DescriptionEnd indicator.Rinse aid indicator. It is always off while the programme operates.Salt indicator. It is alw

Information for test institutesFor all the necessary information for testperformance, send an email to:[email protected] down t

German de‐grees (°dH)French de‐grees (°fH)mmol/l Clarke de‐greesWater softenerlevel23 - 28 40 - 50 4.0 - 5.0 28 - 35 619 - 22 33 - 39 3.3 - 3.9 23 - 2

During the drying phase, thedoor opens automatically andremains ajar.CAUTION! Do not try to closethe appliance door within 2minutes after automaticope