Atag VA5511ATUU/A06 User Manual download pdf (Page 49)

Water connection

Water inlet connection

This dishwasher may be fed with either hot

(max. 60°) or cold water. Nevertheless we

advise you use a cold water supply.

A hot water supply is not always efficient with

heavily soiled crockery as it shortens the

washing programmes a lot.

For making the connection itself, the cou-

pling nut fitted to the machine water inlet

hose is designed to screw onto a 3/4" gas

thread spout or to a purpose made quick-

coupling tap such as the Press-block.

The water pressure must be within the limits

given in the "Technical data". Your local Wa-

ter Authority will advise you on the average

mains pressure in your area.

The water inlet hose must not be kinked,

crushed, or entangled when it is being con-

nected.

The dishwasher features water inlet and drain

hoses which can be turned either to the left

or the right to suit the installation by means

of the locknut. The locknut must be cor-

rectly fitted to avoid water leaks.

Attention! NOT all models of dishwash-

ers have water inlet and drain hoses pro-

vided with a locknut. In this case, this fa-

cility is not available.

If the machine is connected to new pipes or

pipes which have not been used for a long

time, you should run the water for a few mi-

nutes before connecting the water inlet hose.

DO NOT use connection hoses which

have previously been used on an old ap-

pliance.

This appliance has been fitted with safe-

ty features which will prevent the water

used in the appliance from returning

back into the drinking water system. This

appliance complies with the applicable

plumbing regulations.

Installation of an IRG filter is recommen-

ded on the house water system.

Water inlet hose with safety valve

After connecting the double-walled water in-

let hose, the safety valve is next to the tap.

Therefore the water inlet hose is only under

pressure while the water is running. If the wa-

ter inlet hose starts to leak during this oper-

ation, the safety valve cuts off the running

water.

Please take care when installing the water

inlet hose:

• The electrical cable for the safety valve is

in the double-walled water inlet hose. Do

not immerse the water inlet hose or the

safety valve in water.

• If water inlet hose or the safety valve is

damaged, remove the mains plug imme-

diately.

• A water inlet hose with safety valve must

only be replaced by the Service Force

Centre.

Warning! Dangerous voltage

Water drain connection

The water drain hose can face either to the

right or left of the dishwasher

Ensure that the hose is not bent or squashed

as this could prevent or slow down the dis-

charge of water.

The sink plug must not be in place when the

machine is draining as this could cause the

water to syphon back into the machine.

The highest point of the drain hose must not

be more than 500 mm from the base of the

appliance.

When connecting the water drain hose to an

under sink trap spigot, the entire plastic

membrane (A) must be removed. Failure

to remove all the membrane will result in food

particles building up over time eventually

blocking the dishwasher drain hose spigot

49

1 2 ... 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments